Gephi forums

Re: [TODO] Problem w/ selecting nodes w/ HeatMap + Shortest

2016-09-17T16:29:41+01:00

Hi!

I'm new in this forum and also new with Gephi.

Do you know if the Shortest Path tool can show if there´re more than one (several shortest paths)? -I'm using the last version of Gephi.

Thanks in advanced!

Statistics:Posted by uds1923 — 17 Sep 2016 16:29

Re: [TODO] Problem w/ selecting nodes w/ HeatMap + Shortest

2013-07-15T20:33:24+01:00

Two and a half years later (and on version 0.8.2) I still have the same problem.

Statistics:Posted by London Rain — 15 Jul 2013 20:33

Re: Problem with selecting nodes with Heat Map and Shortest

2011-01-27T13:04:32+01:00

Yes, direct selection does not remember the selection when clicking for me too.

But I should check the tools problems when I have some time, thanks for reporting this problem.

Statistics:Posted by eduramiba — 27 Jan 2011 13:04

Re: Problem with selecting nodes with Heat Map and Shortest

2011-01-19T22:10:06+01:00

I'm sure I selected direct selection before clickin on one of the mentioned tools.

However I noticed that I cannot select a node with the direct selection tool by clicking as well. If I hover a node with that tool other nodes will be greyed out but I nothing else happens if I click that node. If I remove the cursor from the node the other nodes will be displayed again without the "fade out effect".

I can however select a single node by drawing a rectangle around it with the other selection tool.

So the root of the problem I mentioned in the first post might be that selecting itself won't work.

Statistics:Posted by London Rain — 19 Jan 2011 22:10

Re: Problem with selecting nodes with Heat Map and Shortest

2011-01-19T22:00:00+01:00

That is strange, it should work fine. Please make sure that direct selection is enabled before clicking, maybe you have rectangle selection enabled.

Statistics:Posted by eduramiba — 19 Jan 2011 22:00

Re: Problem with selecting nodes with Heat Map and Shortest

2011-01-19T16:42:46+01:00

Nobody? Is this perhaps a windows specific problem? Or do I need to keep some other key pressed for the last click?

Statistics:Posted by London Rain — 19 Jan 2011 16:42

[TODO] Problem w/ selecting nodes w/ HeatMap + Shortest Path

2011-01-15T23:58:55+01:00

Using Gephi 0.7 Beta on Win7 64 Bit. If I try to select a node with the shortest path tool (aeroplane symbol) I can select the source node and the heading description changes to "Select a target node". However if I click another node then nothing else will happen and the heading will stay the same no matter which node I click.

Something similar goes for the heat map tool as well. If I select it the heading changes to "Click on a node" but if I click on a node nothing happens.

Any ideas?

Statistics:Posted by London Rain — 15 Jan 2011 23:58